Fully Automatic Water Level Controller and Indicator With Dry Run Protection and Multi- Mode Control | Fully Automatic With Buzzer | Semi Automatic | Manual

Model: IT880WLC

(Fully Automatic Water Level Indicator & Controller)

Package Contains:

    FULLY AUTOMATIC WATER LEVEL CONTROLLER WITH DRY RUN PROTECTION MODEL NO-IT880WLC WITH USER MANUAL.
    SIX SS SENSOR SENSOR FOR UP TANK AND DOWN TANK .
    USER DIAGRAM

Technical Specifications

    Input Voltage: AC 230V

    Output Voltage: AC 230V

    Motor Capacity: Up to 2 HP

    Control System: Overhead and Underground tank control with Dry Run Protection

 Supported Sensors:

        Stainless Steel Sensors

        Carbon Sensors

        Float Switch Sensors

        Magnetic Sensors

Supported Starters:

        Direct ON/OFF Switch

        Monoblock Motor

        Openwell Motor

Not Supported Starters:

        Borewell Starter with Green & Red Push Buttons
        (Not supported for automatic motor starting)

AUTO/MANUAL Switch Functionality

    AUTO Mode:
    Device operates automatically based on the selected working mode and tank levels.

    MANUAL Mode:
    Motor starts when the Green Push Button is pressed.
    Pressing the Green Push Button again will stop the motor.
    (Manual control works regardless of selected mode)

Working Modes

Mode 1: Automatic Mode with Dry Run Protection

(Underground Tank to Overhead Tank)

    Works with both underground and overhead tanks.

    Provides dry run protection.

Motor starts when:

        Overhead tank is empty (G1 & B1 not in water)

        Underground tank is full (G & B in water)

Motor stops when:

        Overhead tank is full (G1 & B1 in water)

        Motor will not start if underground tank is empty (dry run protection).

        G sensor acts as dry run sensor.

        Both G and B must be in water for motor to start.

Mode 2: Automatic Mode (Only Overhead Tank)

    Controls only the overhead tank.

    No dry run protection in this mode.

Motor starts when:

        Overhead tank is empty (G2 & B2 not in water)

Motor stops when:

        Overhead tank is full (G1 & B1 in water)

Mode 3: Semi-Automatic Mode (Only Overhead Tank)

    User must start the motor manually using the Green Push Button.

    Motor stops automatically when:

   Overhead tank is full (B1 in water)

    To restart the motor, press the Green Push Button again.

Mode 4: Automatic Mode with Buzzer (With Dry Run Protection)

(Underground Tank to Overhead Tank)

    Functions exactly like Mode 1.

    Additional buzzer alerts:

        When Overhead tank is full (B1 in water):
        Buzzer sounds 40 fast beeps, then stops automatically.
        Can be stopped immediately by pressing Green Push Button.

        When Underground tank is empty (G not in water):
        Buzzer sounds 40 slow beeps, then stops automatically.
        Can also be muted immediately by pressing Green Push Button.

Mode Selection Instructions

To change the operating mode:

    Press and hold the START/STOP Green Push Button for 6 seconds.

    Buzzer will beep according to selected mode:

        Mode 1 → 1 Beep

        Mode 2 → 2 Beeps

        Mode 3 → 3 Beeps

        Mode 4 → 4 Beeps

Release the button after hearing the correct beep count.
Important Notes

    R1 Sensor must be installed at the bottom of the overhead tank.
    Without R1, the device will not function.

    Ensure all electrical and sensor connections are properly insulated and secure.

    Use only the supported starter types and sensor configurations for best performance.

Customer Support

   Contact: +91 8000066255 (WhatsApp Only)
   Support Hours: 10:00 AM to 7:00 PM
   Days: Monday to Saturday